Action Area interface sometimes appears completely blank

Hi

Was starting to record some video tutorials the other day (I had mentioned I'd try to do this at some point), and found a problem with the Action Area lower interface.

I created a new action area, which appeared in the hierarchy correctly, but when I clicked on it to edit it, the lower part of the interface (where you would add actions etc) flickered black and then didn't draw at all.

This has happened a few times now, and the only way to get it to re-draw is to go to another room, then come back and select the action area again.


I'm on Win7 and use dual monitors, if that helps at all.

Thanks
Andi

I've mentioned this issue to the devs a little while back. For me it would draw/flicker some black bar & the editor would hang for about 10-20 seconds or so & then it would usually show me the action area stuff, but if I left this tab & tried to access it again later on, then the editor usually ended up crashing & burning. This was a couple of updates back mind.

The black bar bit still seems to persist. Probably some issue being caused by wxwidgets or something.